产品中心

服务热线:

18560002720

联系我们
您的位置: 首页 >新闻资讯 > 公司新闻 >
卫生间隔断门的防火等级需要达到什么样的标准?
发布时间:2020-08-10    发布人:富美家防火板小编   网址:https://www.zhumeiyike.com/   点击:
在消防中对防火门等级的划分是有明确规定的,同时也还在参考新标准出台之后对原有防火门等级做了一些调整。对防火门的分类由原来仅按隔热防火门分类,改为按隔热防火门(A类)、部门隔热防火门(B类)和非隔热防火门(C类)进行分类;同时,将以前那种甲、乙、丙级防火门的耐火极限调整为1.5h、1.0h和0.5h这样也让防火门产品的种类变得多了,增加了实际应用的选择余地,对于仅需要防火门具有部门隔热性或耐火完整性要求的应用场合,可以选用部门隔热或非隔热的防火门。
In the fire protection, there are clear regulations on the classification of fire doors. At the same time, some adjustments have been made to the original fire door grades after the introduction of the new standard. The classification of fire doors is changed from thermal insulation doors to thermal insulation doors (Class A), Department thermal insulation fire doors (class B) and non thermal insulation fire doors (Class C); At the same time, the fire resistance limit of the former class A, B and C fire doors is adjusted to 1.5h, 1.0h and 0.5h, which also makes the fire door products more variety and increases the choice of practical application. For the application where only the fire door has the requirements of department thermal insulation or fire integrity, the Department heat insulation or non thermal insulation fire door can be selected.
卫生间隔断门构成
Toilet partition door composition
1、支脚:可夹板厚度12mm(抗贝特板)和18mm(普通板材);可调整高度为110mm-130mm;可定加工成夹任意厚度板材夹口、更高或更低安装高度;可选择采用316L不
1. Support: the thickness of splint can be 12mm (anti bate board) and 18mm (ordinary plate); the height can be adjusted from 110mm to 130mm; it can be processed to clamp any thickness plate, with higher or lower installation height; 316L No
锈钢原材料生产。
Stainless steel raw material production.
2、门锁:旋转式锁把,更易于使用且不受板材变形影响;带紧急开门开关;带有/无人指示牌;内侧旋转式锁把,每90度有定位;指示盘直径为55mm。
2. Door lock: rotary lock handle, easier to use and not affected by plate deformation; with emergency door opening switch; with / without indicator board; inside rotary lock handle, with positioning every 90 degrees; indicator board diameter is 55mm.
3、拉手:直径为38mm;可选择单面安装也可选择里外对穿安装;可选择采用316L不锈钢原材料生产。
3. Handle: diameter is 38mm; it can be installed on one side or inside and outside; it can be made of 316L stainless steel.
济南卫生间隔断
4、角码:厚度3mm;沉头螺丝均经过仔细打磨抛光,更和谐美观。
4. Corner code: 3mm thick; countersunk screws are carefully polished, more harmonious and beautiful.
5、合页:采用自攻螺丝安装,适用于内开门;内有尼龙升降面实现自动回关,并可调整关门角度,内有48个角度可以调整,每次调整7.5度;分左右,以内开门方式区分。
5. Hinge: it is installed with self tapping screw, which is suitable for inner door opening; there is nylon lifting surface inside to realize automatic closing, and the door closing angle can be adjusted. There are 48 angles in the hinge which can be adjusted by 7.5 degrees each time. The inner door opening mode can be distinguished by left and right points.
6、吊杆:可夹板厚度12mm(抗贝特板)和18mm(普通板材);可定加工成夹任意厚度板材夹口、更高或更低安装高度;可选择采用316L不锈钢原材料生产;不锈钢拉杆圆管直径为32mm。
6. Suspender: the thickness of splint can be 12mm (anti bate plate) and 18mm (ordinary plate); it can be processed to clamp plate with any thickness, higher or lower installation height; 316L stainless steel raw material can be selected for production; the diameter of stainless steel rod round pipe is 32mm.